Contact element 1NC, front - Auxiliary contact block 0 NO/1 NC M22-CK01

Contact element 1NC, front - Auxiliary contact block 0 NO/1 NC M22-CK01 – Eaton – 216385 – 4015082163853: Contact element 1Ö, front M22-CK01 Number of contacts as changeover contacts 0, number of contacts as make contacts 0, number of contacts as break contacts 1, number of error signal switches 0, rated operating current Ie at AC-15, 230 V 6A, design of the electrical connection spring-loaded connection, Design can be plugged on and integrated, mounting type: front mounting, socket without, contact element, standard/approval: UL/CSA, IEC, size: NZM1/2/3/4, connection technology: cage clamp, mounting: front mounting, description: Cage Clamp is a registered trademark from Wago Kontakttechnik GmbH, Minden, contact configuration NC = NC contact: 1 NC, contact configuration Note: = safety function, through positive opening according to IEC/EN 60947-5-1, travel of the control panel and actuation force according to DIN EN 60947-5-1, K.5.4 .1 Forced opening travel: mm 4.8, maximum travel: mm 5.7, minimum force for positive opening: N 15, protection class: IP20, connection to SmartWire-DT: no, connection type: single contact, description of tripped auxiliary switch HIA: general tripped message + when tripped by voltage release, overload release, Short-circuit release and when using the residual current release due to residual current. Use with circuit breaker size NZM1, 2, 3: A tripped auxiliary switch can be clipped into the circuit breaker. Use with circuit breaker size NZM4: Up to two tripped auxiliary switches can be clipped into the circuit breaker. Any combination of auxiliary switch types is possible. Not in conjunction with PN switch disconnector, marking in the switch: HIA. Marking in the FI block: HIAFI. When using the tripped auxiliary switches in the FI block, the normally closed contact works as a normally open contact and the normally open contact works as a normally closed contact. Description Normal auxiliary switch HIGH: Switches with the main contacts. Takes on reporting and interlocking tasks. Use with circuit breaker size NZM1: A standard auxiliary switch can be clipped into the circuit breaker. Use with circuit breaker size NZM2: Up to two standard auxiliary switches can be clipped into the circuit breaker. Use with circuit breaker size NZM3, 4: Up to three normal auxiliary switches can be clipped into the circuit breaker. Any combination of auxiliary switch types is possible. Marking in the switch: HIN. When combined with the NZM-XR remote drive, the right-hand installation location for the normal auxiliary switch HIN can only be equipped with individual contacts. Can be used for: NZM1(-4), 2(-4), 3(-4), 4(-4), PN1(-4), 2(-4), 3(-4), N(S)1 (-4), 2(-4), 3(-4), 4(-4), standards and regulations: IEC 60947-5-1