Impulse switch for EB 1S 10A - Latching relay 12...24V AC/DC ES75-12..24V UC

Impulse switch for EB 1S 10A - Latching relay 12...24V AC/DC ES75-12..24V UC – Eltako – 60100055 – 4010312101063: Impulse switch for EB 1S 10A ES75-12..24V UC Function other, type of installation other, width in modular units 2.22, installation depth 28mm, number of contacts as NO contact 1, number of contacts as NC contact 0, number of contacts as changeover contact 0, Control voltage 1 12 ... 24V, type of control voltage 1 AC/DC, rated switching current 10A, supply voltage 250 ... 250V, type of supply voltage AC, max. incandescent lamp load 500W, max. 24V UC. 1 NO contact not potential-free 10A/250V AC. Standby loss only 1 watt. For flush mounting. 85mm long, 40mm wide, 28mm deep. With integrated transformer for galvanic isolation between control circuit and circuit to meet the requirements for safety extra-low voltage SELV according to EN 60669-2-2. From production week 18/18, the safety requirement 2x MOPP according to EN 60601-1 will also be met. Control with the internal voltage or an external control voltage of 12 to 24V UC, control current 10mA at 24V. Permanent power supply 230V. A fuse with a maximum of 10 A is required. For incandescent lamps and halogen lamps up to 500W and fluorescent lamps with CCG in DUO circuit up to 1000VA. Fluorescent lamps with KVG parallel compensated 300VA. Temperature at the installation site between -20 degrees C and +50 degrees C. Command minimum duration/command pause 20/300ms. Connections on the low-current side 4-pin pin housing for plug STOCKO MKF13264-6-0-404, 230V side 6-pin terminal strip with plug-in terminals, maximum conductor cross-section 2.5mm2. A Stocko plug is included with every device.