Window actuator 1-gang KNX flush-mounted - KNX combined I/O device 216400

Window actuator 1-gang KNX flush-mounted - KNX combined I/O device 216400 – Gira – 4010337075936: Window actuator 1-gang flush-mounted KNX/EIB 216400 bus system KNX, other bus systems without, mounting type flush-mounted, number of inputs 3, max. number of switching outputs 1, max. number of blind outputs 1, protection class (IP) IP20, KNX combination actuator blinds and heating flush-mounted features: Free assignment of the functions switching, dimming, blinds and value transmitters to the inputs. Blocking object for blocking individual inputs. Behavior when bus voltage returns can be parameterized separately for each input. Telegram rate limitation. Switching function: two independent switching objects available for each input and can be activated individually, command can be set independently on rising and falling edges (ON, OFF, TOGGLE, no reaction). Dimming function: Single-surface and dual-surface operation, time between dimming and switching and dimming step width adjustable, telegram repetition and stop telegram sending possible. Blind function: command can be set on a rising edge (no function, UP, DOWN, TOGGLE), operating concept can be parameterized (Step - Move - Step or Move - Step), time between short and long-term operation can be set, slat adjustment time can be set. Function of value transmitter and light scene extension: Edge (button as make contact, push button as break contact, switch) and value at edge can be parameterized, value adjustment for button via long key press for value transmitter possible, light scene extension with memory function also saving the scene without prior retrieval possible. The combination actuator for blinds and heating is a combination of a blind actuator with a heating actuator and has three binary inputs with which the connected blinds, roller shutters, awnings or ventilation flaps can be controlled in the delivery state. Operating mode can be parameterized: blinds, roller shutters, awnings or ventilation flaps. Separately parameterizable blind travel times with travel time extension for travel to the upper end position. Feedback of the blind position or the slat position. Active or passive (object readable) cyclic feedback functions. Assignments to up to five different safety functions (three wind alarms, one rain alarm, one frost alarm), optionally with cyclic monitoring. Sun protection function can be activated with fixed and variable curtain or slat positions. Integration into complex shading controls, optionally with automatic heating/cooling and presence functions. Behavior in the event of bus voltage failure and recovery can be set. Feedback can be delayed after bus voltage returns. Forced position function can be implemented for every blind output. Inclusion in scenes possible, a maximum of eight internal scenes per channel can be parameterized. Memory function for light scenes. Output, controllable by a manipulated variable (1 bit or 1 byte). Status feedback (1 bit or 1 byte) automatically or on read request. Valve control (open closed without voltage) can be parameterized. Summer or winter operation can be selected via an object. Cyclic monitoring of the manipulated variable: if a manipulated variable telegram is not received within a monitoring time, the output switches to emergency mode and an alarm message is sent. Each output can be locked in a forced position (forced position); different values are possible for summer and winter operation. Behavior in the event of bus voltage return or failure can be parameterized separately for each output. Overload or short-circuit message can be set via an object. Control of the actuators in switching mode or PWM mode. Protective function against stuck valve. Notes: For installation in a device box (recommendation: an electronics box from Kaiser). Flush-mounted, Kaiser order no.: 1068-02, hollow wall, Kaiser order no.: 9062-94, halogen-free, Kaiser order no.: 9062-74. The outputs are connected via a flexible cable approx. 20 cm long. The binary inputs and the KNX bus are connected via a 6-wire, approx. 30 cm long connection cable, which can be extended to a maximum of 5 m. VDE approval according to EN 60669-1, EN 60669-2-1.